LEAKOIL Forum

CraigOnTheBoat wrote:Your not done yet, that disco bus needs this on the top.

http://www.youtube.com/watch?v=8h-mb6bd ... r_embedded

Oh man, that would be sweet to have on the roof!!!

Nice Brandon it looks awesome. Big improvement since the last time I saw it. Are you going to the November meeting. If so would love to see some more pics.

Worked all day Saturday on this top and still didn't get it done all the way. I ended up pulling the sides too tight and ended up with excess fabric towards the back. To correct that I will need to take out some of the screws from both sides and pull the fabric back a bit. A special thanks to Kyle and Bill for allowing me to use their shops to complete this project. Also a special thanks to Dan for replacing the numerous seals on my Bus. I will hopefully be finishing up tomorrow with the top so I can get it home to put in the panels and new floor and then reassemble the interior.

Mbkeith74 wrote:Nice Brandon it looks awesome. Big improvement since the last time I saw it. Are you going to the November meeting. If so would love to see some more pics.

I'll hopefully be driving the Bus to the November meeting.

Well sweet let me know if you want to meet up and go out there.

Is it spring yet? I'm going stir crazy not being able to drive any of these VW's. Anyways, a few Fridays ago Josh assisted me..(wait maybe I was the one assisting him) by yanking the motor out of my Bus and getting it over to his house for a REBUILD!! Last night we successfully tore down the engine to see what we're dealing with. From the looks of it, it has already been rebuilt a while back (with some crappy parts too, GEX heads ). But with a little hard work, we'll have it back to it's former glory.

Josh and I keep plugging along with my engine rebuild. Now I'm just waiting on heads from Rich Sedoris and I still need to purchase carbs, fuel pump, distributor, clutch, etc, etc.

Throughout the week I've been slowly getting all of the engine tin cleaned up and painted.






Assembled crankshaft


Case half


Case halves ready to be assembled together.




Crankshaft and cam installed


Shortblock assembled!!!

...

It's all good, just hard to see in the pic. He triple checked them!

I see you tested the Budweiser as well. Very thorough!